Latency additional is introduced when Reamping respect to the original Analog Direct Recording, with MBOX Pro the additional latency is a delay of around 55-65 samples (1,2-1,5 ms).To Reamp more times the same track and avoid phase issues it’s needed to use a constant latency (Output Menù – ) that will be of 4,5 ms.Outputs 3/4 or SoftWare Return 3+4 Active = 0db (all the others Software Return Output on Mute) Ģ) SPDIF Out Mixer = Stereo Mix with active only the Software Return Output 3+4 and all the rest (Input and Output) on Muteģ) CLOCK In the MBOX Control Panel Setup Menù put Clock Source = SPDIF andīufferSize (latency) lower or equal to 256 (5,8 ms) Sample Frequency 44,1 KHzġ) Connect the SPDIF In from the MBXOX to the SPDIF Out of the KemperĢ) Connect the SPDIF Out from the MBXOX to the SPDIF In of the Kemperģ) Connect the Main Analog Out Left+Right from the Kemper to the Analog In 1+2 of the MBOX This configuration is for the MBOX Pro Control Panel but can be used for any Sound Cardġ) Outputs 1/2 = Stereo Mix with Input 1+2 Active = 0db, all the others Input on Mute (including SPDIF Input 7+8 to avoid to listen to Direct Signal of the guitar in the recording monitoring) Main Output 1+2=0db STEP 2 – Reamped Signal Recording (using Main Out for Analog Reamp recording or SPDIF Output for Digital Recording)ġ) Arm 3rd track (Input 1+2) for recording the full processed reamped signal from the KPA Analog Main OutĢ) Route the DAW Output (from Mixer) of the SPDIF Dry Track previously recorded to Out 3+4 (=Software Returns 3+4 or Digital OUT)ġ) Output Page on “Reamp” with Main Out = Master Stereo (for Analog out recording) or Page on “Default OUT” with SPDIF Out = Master Stereo (for Digital out recording)Ģ) Input Page with Input = SPDIF Input (only the left channel of the SPDIF Input will be taken for the Reamping) and, if possible, CleanSense=0, DistortionSense=0 and ReampSense=0 (it simplify the process) STEP 1 –Direct Signal Recording (using SPDIF Output for the Dry recording and Main Analog Out for monitoring)ġ) Arm 1st track (Input 1+2) for recording the full processed signal from the KPA Analog Main OutĢ) Arm 2nd track (Input 3+4) for recording the dry signal from the KPA Digital SPDIF Outġ) Output Page on “Reamp” with Main Out = Master Stereo and SPDIF Out = Studio Git or any other with Git on the Left channel (only the left channel of the SPDIF Input will be taken for the Reamping)Ģ) Input Page with Input = Front Input and, if possible, CleanSense=0 and DistortionSense=0 (it simplify the 2 nd step of the reamp process) (this guide is tested and builded for MBOX Audio Interface but can be easily used for any sound card that have at least 2 analog in, 2 SPDIF in, 2 analog out and 2 SPDIF out)
0 Comments
Leave a Reply. |